Uverse Remote Control Setup Code List
If you want to setup your Uverse Remote control then you will need the setup code that corresponds to your television set.
Uverse Remote Resetting to Factory Defaults
A. Resetting the Remote Control to Factory Default Settings:
1. Press and hold the AT&T key on the remote control
2. Without releasing the AT&T key, press and hold the OK key.
3. Release both the AT&T key, and the OK key
- All four mode keys will flash twice to indicate programming mode.
4. Enter programming code 900 by pressing the number keys on the remote control.
- The AT&T key will flash three times indicating you have successfully entered the code and the remote has been reset to the
default settings
Note:
If any other key is pressed except the number keys the AT&T key will give a long red flash and the remote control will return to normal operation. Should the remote control time-out before you complete the procedure you will need to start over.
B. Resetting the Volume, Channel and Power Programming:
1. Press and hold the AT&T key on the remote control.
2. without releasing the AT&T key, press and hold the OK key.
3. Release both the AT&T key and the OK key.
- All four mode keys will flash twice to indicate programming mode
4. Enter programming code 902 by pressing the number keys on the remote control.
- The AT&T key will flash three times indicating you have successfully entered the code to set all of the mode keys as inactive and the remote will return to normal operation.
Note:
If any other key is pressed except the number keys the AT&T key will give a long red flash and the remote control will return to normal operation. Should the remote control time-out before you complete the procedure you will need to start over.